Introduction; Symbols Used; General Safety Instructions - Burkert 8045 Mode D'emploi

1.1

SYMBOLS USED

Indicates information which must be followed. Failure to follow the
information could endanger the user and affect the function of the device.
Indicates that the page contains general information.
Indicates a quickstart guide for quickly commissioning the transmitter.
Indicates that the page contains information about installation.
Indicates that the page contains information about configuration, programming
and operation.
Indicates important information, tips and recommendations.
Indicates a worked example.
Indicates an action which has to be continued or reference to a relevant
section.
Indicates information about repairs, service, maintenance and spare parts.
1.2

GENERAL SAFETY INSTRUCTIONS

Congratulations on purchasing our 8045 Electromagnetic Flow Transmitter.
Before installing or using this product, please read this manual and any
other relevant documentation to ensure you fully benefit from all the
advantages the product can offer.
Please verify that the product is complete and free from any damage.
(see reference table section 6.5).
It is the customer's responsibility to select an appropriate transmitter for the
application, ensure the unit is installed correctly, and maintain all components.
This product should only be installed or repaired by specialist staff using the
correct tools.
Please observe the relevant safety regulations throughout the operation,
maintenance and repair of the product.
Always ensure that the power supply is switched off before working on the
device / system.
If these instructions are ignored, no liability will be accepted and the guarantee
on the device and accessories will become invalid.
8045

INTRODUCTION

3
Fluid Control Systems