Batch Controller Se35; Introduction; Unpacking And Control; About This Manual - Burkert SE35 Notice D'utilisation

1 INTRODUCTION

Dear Customer,
Congratulations on your purchase of our
batch controller type SE35 INLINE.
Before installing or mounting this device,
please take our advice and read the entire
manual thoroughly.
This will enable you to fully profit from all of
the advantages offered by this product.

1.1 Unpacking and Control

Please verify that the product is complete
and free from any damage. The standard
delivery must include:
-1 Batch Controller electronic type SE35
-1 Instruction manual type SE35
-1 Instruction manual type S030 Inline
Compare the type specification on the
label to the following list to ensure that
you have received the proper unit.
If there is any loss or damage, please contact
your local Bürkert subsidiary.

1.2 About this Manual

This manual does not contain any warranty
statement. Please refer to our general terms
of sale and delivery.
Only properly-trained staff should install and/
or repair this product. If difficulties
should occur at the time of installation,
please contact your nearest Bürkert sales
office for assistance.

BATCH CONTROLLER SE35

1.3 User's Responsibility for Safety

Bürkert manufactures a broad range of flow
sensors. While each of these products is
designed to operate in a wide variety of
applications, it is the user's responsibility to
select a controller model that is appropriate
for the application, install it properly, and
maintain all components. Special attention
must be paid to the chemical resistance of
the sensor against the fluids which are
directly contacting the product.
This symbol appears in the
! manual to call special attention to
instructions that affect the safe
installation, function and use of the product.

1.4 Electromagnetic compatibility

This device conforms to the EMC-Directive
of the Council of European Communities
89/336/EEC.
In order to comply with this directive, the
wiring instructions must be followed.
E-2-
8035