Display Of Flow Rate And The Initial Preset Volume During The Dosage - Burkert SE35 Notice D'utilisation

4 CONFIGURATION
4.3.3. Dosing proportional to a pulse duration («EXT.[T]» Option)
This option enables the initiation of a dosing volume proportional to the time during which
binary data input 1 is enabled. The following prompts are displayed within the principal
menu during the dosing operation.
Totalizer
display
Fig. 9 Exemple of electrical connection
L+(12...30VDC)
«ALARM» prompt during the dosing operation: dosing problem (see § 5.1.).
During the dosing of the selected volume, it is possible to display the flow rate, to pause,
to reset or to stop the operation. These facilities are only selected on the keypad. (see §
4.3.4. and § 4.3.5)
4.3.4. Display of flow rate and the initial preset volume during the dosing.
To display the flow rate and of the initial preset volume values during the dosing operation,
press the key briefly. This is a useful facility irrespective of the dosing option chosen.
Countdown of the
dosing operation
in progress
221 L
8035
2885 L
Activation time
proportional to
dosing volume
1 2 3 4 5 6 7 8 9
GND
Initial preset volume
250 L
2 s.
BATCH CONTROLLER SE35
Countup of the
volume to 0
38
1
+ -
PLC, switch, push
button, etc.
Flow rate
2.34 L/S
2 s.
Automatic refresh after 2 s
E-17-
L
Batch controller
type 8035 INLINE
PE
GND
L+(12...30VDC)