Raleigh PEDELEC IMPULSE EVO Notice Originale page 207

Do not switch the pedelec off whilst you are riding it. This can cut out the motor or mean you do not receive full assist.
11.2 Battery
Display Description
 5 LEDs flash quickly
after the battery button is
pressed.
 The 1st LED flashes
rapidly after pressing the
battery button.
No LEDs light up after
pressing the battery
button.
The range appears too
short
EN-100 Original User Guide | Pedelec Impulse Evo / Impulse Evo Next Version 4
Cause
a) Battery is flat and is disabled.
b) The battery is overloaded.
c) The battery is too cold or too hot.
There is a charging fault.
The battery is faulty.
a) The range depends on:
» Ride profile
» Assist mode
» Tyre pressure
» Riding style
» Physical condition
» Overall weight
» Outside temperatures
» Battery capacity
» The route selected
» Smartphone charging via display
Remedy
a) I f the battery is flat, it will work again briefly after a short recovery period, then switch off
again. It must now be charged  10.3.1 Charging a battery Page
b) If the battery is overloaded, it switches itself on again after a short rest period and can be used
again as normal.
c) The permitted ambient temperature range during operation range of the battery is -10 to +40 ˚C.
Unplug the charger from the mains immediately. If the problem reoccurs, a new battery
charger is required.
Please contact your cycle dealer. The battery must be replaced.
a) The are many reasons why the range may seem low
EN-93.
 9.4.1 Range Page EN-88.