Shift Unit: Shifter Adjustment - Raleigh PEDELEC IMPULSE EVO Notice Originale

2. You can select between different start gears and setting "Off" (no start
gear):
1 2 3
1st gear 2nd gear 3rd gear 4th gear
*The number of gears displayed depends on the gear shifter you have.
3. Select the required option using the / buttons. The selection is
highlighted.
4. Confirm your selection by briefly pressing the button.
You return to column "Top Gear at".
Top Gear at
Here you can select the speed at which the shift (in the automatic mode)
should shift to the highest gear.
20 km/h 22 km/h 24 km/h
5. Select the required option using the / buttons. The selection is
highlighted.
6. Confirm your selection by briefly pressing the button. You return to
sub level 3.
For sporty riders, who feel comfortable with higher cadence,
we recommend the adjustment range 28 to 32 km/h.
Cyclists who prefer lower tread frequencies feel the most
comfortable at speeds of 20 to 26 km/h
4 5 6 7
5th gear 6th gear 7th gear
26 km/h 28 km/h 30 km/h
3.10.1.4

Shift unit: Shifter adjustment

Path: Settings | Device settings | Shift unit | Shifter adjustment
Off
The electronic shifter works with a gear cable. This cable can easily stretch
No gear
over its life, or needs to be readjusted after being renewed. You can
perform fine adjustment of the tension in "Shifter adjustment".
1. Navigate to the "Settings" menu as described in
settings in the main menu Page
2. You can choose between:
-2.50 mm -2.00 mm -1.50 mm -1.00 mm -0.50 mm 0.00 mm 0.50 mm 1.00 mm 1.50 mm 2.00 mm 2.50 mm
3. Select the required option using the / buttons. The selection is
highlighted.
4. Confirm your selection by briefly pressing the button. You return to
sub-level 3.
32 km/h
IMPORTANT
The shifter is adjusted correctly when the
two yellow marker lines line up exactly.
Whether this is so, you can fix in the
adjustment gear (mostly the 4th gear). If
the adjustment range is too short, i.e. it
is not possible to line up the two yellow
marker lines, the position of the gear hub
sliding block must be moved.
Original User Guide | Pedelec Impulse Evo / Impulse Evo Next Version 4
 6.4.1 Configuring
EN-54.
Marker line
EN-29