3.4 Adjusting The Sprung Seatpost En; Adjusting The Height And Angle; Switching The Lights On And Off* En - Raleigh PEDELEC IMPULSE EVO Notice Originale

3.4 Adjusting the sprung seatpost
DANGER
It is best to ask your cycle dealer to adjust the suspension elements of
the seatpost.
1. Remove the seatpost.
2. Tighten the suspension adjustment screw with an Allen key (6 mm
AF) in the clockwise direction to reduce the suspension or loosen
anticlockwise to increase the suspension.
DANGER
The suspension adjustment screw must not
protrude from the seatpost, otherwise the
screw/seatpost can loosen – if this happens
while riding you could fall off, resulting in
serious injuries.
*dependent on model
3.5
3.6
A slider control is located on the rear of the front light. Depending on
which way you move it, the front and rear light will be on or off when you
are riding.
Suspension
adjustment
screw
Screw must not protrude
from the seatpost
Adjusting the height and angle of the handlebars
DANGER
Ask your cycle dealer to perform these adjustments. You can otherwise
run the risk of loosening the handlebars which could lead to a fall
causing severe injuries.
Switching the lights on and off
Original User Guide | Pedelec Impulse Evo / Impulse Evo Next Version 4
*
EN-21