Raleigh PEDELEC IMPULSE EVO Notice Originale page 201

4. All five LEDs 
light continually on the battery when it is fully
charged. No LED flashes.
5. Remove the power cable from the socket after completing the charging
process.
6. Remove the charging cable from the battery charging socket.
Charging the battery with charger type 2
1. Connect the power cable to the battery charger.
2. Fold up the protective cap on the battery.
3. Connect the charging cable to the battery charging socket (it clicks into
place).
4. Insert the mains plug into a power socket. The red LED lights red
briefly, then the green LED flashes at a constant speed
5. The charger switches off once the battery is fully charged. The green
LED on the charger is continually on
battery light continually. No LED flashes.
EN-94 Original User Guide | Pedelec Impulse Evo / Impulse Evo Next Version 4
.
 . All five LEDs  on the
If the battery now stays on the charger, the charger
regularly checks whether the battery is still fully charged.
The charger LED starts to flash again. After checking and
ascertaining that the battery is full, the charger switches
back to "light continually".
6. Remove the power cable from the socket after completing the charging
process.
7. Remove the charging cable from the battery charging socket.
8. Fold down the protective battery cap.
10.3.1.1 Battery display during charging
Display Description
5 LEDs light up and no LED flashes

4 LEDs light up and the 5th LED flashes


3 LEDs light up and the 4th LED flashes


2 LEDs light up and the 3rd LED flashes


1 LED lights up and the 2nd LED flashes


 1 LED flashes
Battery charge level
100 – 97%
80 – 96%
60 – 79%
40 – 59%
20 – 39%
0 – 19%