Sentiotec Pro C2 Instructions De Montage Et Mode D'emploi page 76

Installation instructions, only for experts
Decreasing the maximum temperature to 105 °C
The preset temperature can be set to between 30 °C and 110 °C as standard. If
you wish to decrease the maximum temperature from 110 °C to 105 °C, perform
the following steps:
1. Open the technician menu (see 26).
2. Turn the top knob to the temperature symbol (position A – see point 9.2 on
page 31).
► The temperature symbol flashes.
► In the top display, "SEnB" appears.
3. Press the bottom knob once or twice until "t HI" appears in the top display.
► In the bottom display, "110" appears.
4. Turn the bottom knob to the left.
► In the bottom display, "105" appears.
► The maximum temperature was decreased from 110 °C to 105 °C.
Setting the parameters of the PI controller
The time constant of the PI controller (I-component) is set to 350 as standard.
If you wish to change this value, perform the following steps:
1. Open the technician menu (see 26).
2. Turn the bottom knob to the temperature symbol (position A – see point 9.2
on page 31).
► The temperature symbol flashes.
► In the top display, "SEnB" appears.
3. Press the bottom knob several times until "PItn" appears in the top display.
4. Turn the bottom knob to the left or right to decrease or increase the time
constant of the PI controller.
WORLD OF WELLNESS
p. 28/48