Settings In The Technician Menu - Sentiotec Pro C2 Instructions De Montage Et Mode D'emploi

Installation instructions, only for experts
Status output
The remote start function is activated or deactivated using the function selection
switch 7.
● The function selection switch 4 is set to the OFF position as standard. The status
output is therefore activated.
● If you wish to activate the foil sensor, place the function selection switch 7 in
the OFF position.
Setting the operating mode for the additional output
The additional output can either be regulated or switched on and off. The dimmer
switch function is activated or deactivated using the function selection switch 8.
● The function selection switch 8 is set to the ON position as standard. The
dimmer switch function is therefore activated.
● If you wish to deactivate the dimmer switch for the additional output, place
the function selection switch 8 in the OFF position.
8.2.

Settings in the technician menu

Opening the technician menu
Additional settings can be made in the technician menu. To access the technician
menu, perform the following steps:
1. Switch off the sauna control unit.
2. Press the bottom knob and the ON/OFF switch at the same time.
► In the top display, "SEtt" appears briefly.
► The two knobs flash.
You do NOT have to confirm the settings in the technician menu. The
settings are saved automatically as soon as you close the technician
menu (see page 32).
WORLD OF WELLNESS
p. 26/48