LiftMaster CB22 Instructions page 34

PROGRAM TX4UNI
Insert radio module on designated pins, if not pre-installed.
The receiver has two channels CH1 and CH2.
The respective LEDs CH1 and CH2 are assigned to these two channels.
Receiving a signal from a programmed remote control button, CH1 fully
opens the gate. Receiving a signal from another programmed remote
control button, CH2 partially opens the gate (pedestrian mode).
Program the remote control using CH1
(fully opens the gate, shown adjacent):
1. Press and hold left and right button of the remote control
simoultaneously for about 5 seconds until its LED comes on
constantly for approx. 30 seconds.
Now select one of 4 buttons you wish to operate the gate with
(do not press yet).
2. Press button CH1. LED LEARN1 comes on for approx 10 seconds.
3. Within these 10 seconds:
- press now the previously selected button of the remote control.
- as control board and remote control are now going to adjust a
matching code, the button on the remote control must be possibly
pressed a second or third time.
- Once LED LEARNTIMER and then all other LED have flashed
proceed with step 4.
4. Press one of the remaining 3 buttons of the remote control to end
programming using CH1.
Note: If step 3 failed wait for the LEDs (control board and remote
control) to go out. Then start again with step 1.
Up to 128 remote controls can be programmed likewise.
Program the remote control using button CH2
(partially opens the gate) :
1. Press and hold left and right button of the remote control
simoultaneously for about 5 seconds until its LED comes on
constantly for approx. 30 seconds. Now select another button
of the remote control to operate only one wing (do not press yet).
2. Press button CH2. LED LEARN2 comes on for approx. 10 seconds.
3. Within these 10 seconds:
- press now the newly selected button of the remote control.
- as control board and remote control are now going to adjust a
matching code, the button on the remote control must be possibly
pressed a second or third time.
- Once LED LEARNTIMER and then all other LED have flashed
proceed with step 4.
4. Press one of the remaining 3 buttons of the remote control
to end programming.
Note: If step 3 failed wait for the LEDs (control board and remote
control) to go out. Then start again with step 1.
Up to 128 remote controls can be programmed likewise.
To delete the programmed transmitter setting, simply press button CH1
until the LED goes out. Proceed in the same way for CH2.
TEACHING / DELETING THE HAND-HELD TRANSMITTERS
Press button CH1. The LED "Learn1" lights up red. Now press one of
the transmitter's button for approx. 5 seconds. The LED "Learn 1"
flashes now. Finished. Proceed in exactly the same way for CH2.
However, now press one of the transmitter's buttons that has not yet
been assigned. Up to 128 hand-held transmitters can be
programmed in this way.
To delete the programmed transmitter setting, simply press button
CH1 until the LED goes out. Proceed in the same way for CH2.
1
2
3
4