Corrective Action - SATA spray master RP Mode D'emploi

Operating Instructions SATA spray master RP
EN
(address see chapter 16).
Malfunction
Jerky spray fan pat-
tern (wobbling / splut-
tering) or air bubbles
in the gravity flow cup.
Spray pattern too
small, slanted,
one-sided or split.
Round / flat fan control
cannot be regulated.
Spray gun does not
shut air off.
Material splutters in
gravity flow cup.
Corrosion on air cap
thread, material pas-
sages (material con-
nection) or spray gun
body.
124
Cause
Fluid tip not tightened. Tighten fluid tip with
Air cap holes clogged
with paint.
Damaged fluid tip
(fluid tip aperture).
Control has been
turned counterclock-
wise over the limit;
spindle loose in gun
thread.
Air piston seat
clogged.
Air piston worn.
Atomising air gets into
gravity flow cup via
paint channel. Fluid
tip not tightened suf-
ficiently. Air cap not
screwed on complete-
ly, air circuit clogged,
seat defective or noz-
zle set damaged.
Cleaning solution (wa-
tery) remains in the
gun for too long.
Unsuitable cleaning
solution.

Corrective action

universal spanner.
Clean air cap. Heed
cleaning instructions
(see chapter 10).
Check fluid tip for any
signs of damage, re-
place nozzle set if nec-
essary.
Unscrew control with
open-end spanner;
make serviceable or
replace completely.
Clean air piston seat.
Heed cleaning instruc-
tions (see chapter 10).
Replace air piston and
air piston packing.
Tighten, clean or re-
place parts.
Have gun body re-
placed. Heed cleaning
instructions (see chap-
ter 10).