Care And Storage - SATA spray master RP Mode D'emploi

Operating Instructions SATA spray master RP
EN
■ Remove trigger guard [1-12] (see chapter 9.1).
■ Screw locking screw [1-6] out of gun body.
■ Pull air micrometer [1-5] out of gun body.
■ Remove air piston with air piston spring.
■ Remove air piston rod [# 29629].
■ Screw gland [# 3749] out of gun body using universal spanner.
■ Pull seal [# 422] out of gun body.
Mount seal
■ Insert seal in gun body [# 422].
■ Screw gland [# 3749] into gun body using universal spanner.
■ Insert air piston rod in the correct position.
■ Insert air piston with air piston spring [10-3] and air micrometer and
grease with SATA high performance grease (# 48173).
■ Press air micrometer into gun body.
■ Screw in locking screw.
■ Mount trigger guard (see chapter 9.1).
■ Insert spring and paint needle.
■ Screw adjusting screw [1-4] with counter nut into gun body.
After installation, adjust the material flow according to chapter 8.2.
9.6. Replace spindle of round / flat fan control
Replacement is necessary if air escapes from the round / flat fan control or
if it is no longer possible to adjust the spray fan pattern.
Dismantle spindle
■ Unscrew countersunk screw [# 1503].
■ Pull off control knob [# 3657].
■ Screw spindle [# 54221] out of gun body using SATA universal span-
ner.
Mount the spindle
■ Screw spindle [# 54221] into gun body using SATA universal spanner.
■ Position control knob [# 3657].
■ Coat countersunk screw [# 1503] with Loctite 242 and screw handtight.

10. Care and storage

Careful handling together with constant care of the product is necessary
to ensure that the spray gun functions properly.
■ Store the spray gun in a dry place.
■ Clean the spray gun thoroughly every time after it has been used and
every time before changing the material.
122