Operation; First Use - SATA spray master RP Mode D'emploi

Operating Instructions SATA spray master RP
EN

8. Operation

Risk of injury from bursting compressed air hose
If an unsuitable compressed air hose is use, it can be damaged by too
much pressure and explode.
→ Only use solvent-resistant, antistatic and technically flawless hose
for compressed air with permanent pressure resistance of min. 10 bar,
bleeder resistance of < 1 MOhm and min. inner diameter of 9 mm
(# 9902).
Damage from dirty compressed air
Using soiled compressed air can cause malfunctions
.
→ Use clean compressed air. For example with SATA filter 100
(# 148247) outside the spray booth or SATA filter 484 (# 92320) inside
the spray booth.
Before using the spray gun, heed / check the following points to warrant
safe working:
■ Check that all screws [# 1503], [# 61416] and [# 133967] are tight-
ened securely. Tighten screws if necessary.
■ Check that air cap is tightened securely.
■ Fluid tip tightened with a torque of 14 Nm.
■ Technically clean compressed air is being used.

8.1. First Use

■ Blow through the compressed air hose thoroughly before installation.
■ Purge paint channel with suitable cleaning solution.
■ Screw connection nipple onto air connection.
■ Connect compressed air hose to air valve [1-9].
■ Adjust cup inner pressure to the material
being used.
■ Align the air cap.
■ Align the air cap horns vertically for a horizontal fan pattern.
■ Align the air cap horns horizontally for a vertical fan pattern.
116
Warning!
Attention!