Invacare Aquatec Ocean VIP Manuel D'utilisation page 12

Aquatec® Ocean VIP / VIP XL / Dual VIP
WARNING!
Risk of injury due to damaged backrest buckles!
Check for secure fastening of the backrest buckles each
time the product is maintained or reconditioned.
– Check all buckle clips for secure fastening by closing
the buckles and pulling on both ends.
– Replace the backrest/backrest buckles if a buckle
opens under the applied force.
Adjusting the height of the armrests
IMPORTANT!
– Adjust the height of the armrests to suit the user.
– Change the height of the armrests evenly on both
sides.
– Set the height of the right and left armrest in the exact
same manner.
12
1. On the backrest cover, open the buckle of the belt that passes
on the inside of the backrest frame.
2. On the backrest cover, open the buckle of the belt C that runs
above the armrest.
3. Pass this belt on the inside of the backrest frame and re-close.
The nuts are inserted loosely in the retaining clamp and can
fall out.
Unscrew the screws B of the armrest bracket A using the Allen
4.
key supplied.
Remove the securing clamp D with the nuts from the inside
5.
of the backrest frame.
6. Remove the backrest bracket A with the armrest and move
it upwards.
The smaller hole serves to fix the retaining clamp.
7. Insert the screws in the armrest bracket and guide them through
the holes in the backrest frame.
8. If required, put the nuts back into the retaining clamp.
9. Place the retaining clamp on the backrest frame so that the fixing
on the retaining clamp projects into the smaller hole.
10. Turn the screws in the nuts and tighten.
11. Pass the belt of the backrest cover that is still open on the
outside of the backrest frame, close and tighten all belts.
IMPORTANT!
The armrests are lowered using the same procedure.
– When converting to the lower position, the belt that
lies beneath the armrest must be opened and passed
inside the backrest frame.
1563142-B