Invacare Aquatec Ocean VIP Manuel D'utilisation page 11

1. Push down all four red foot pedals for the casters to lock them.
IMPORTANT!
– Make sure the armrests are facing forward when
folded up.
2. Push the backrest A from behind onto the pin on the seat frame
D until the collar of the backrest touches the seat frame tube.
IMPORTANT!
– Tighten the screws using the Allen key supplied. The
torque is 5 Nm.
– Regularly check that the screws are firmly fitted.
3. Tighten the backrest on the left and right sides using two screws
B on each side and tooth lock washers C.
Adjusting the backrest cover
The tension of the backrest can be adjusted as desired.
1563142-B
WARNING!
– Make sure that at least three belts are always passed
by the backrest frame (on the outside) and their belt
locks are closed.
To attach accessories, the second belt lock can be opened
from above and the backrest cover can be passed by the
backrest frame on the inside at point C.
Tightening:
1. Pull the belts A of the backrest cover tighter.
Loosening:
Open the buckles B by squeezing the retaining lugs together
1.
(arrows).
2. Push the belts back a little through the buckle.
3. Close the belt buckles.
4. Retighten the belts gently.
Setup
11