Sony DSR-20MD Mode D'emploi page 30

Recording
To video equipment without DV jack
26 GB
Chapter 2 Recording and Playback
Player
Other VCR
to the S-video
input jack
to the video output jack
to the audio output
jacks
to the LANC jack
S-video cable (not supplied)
Video cable (not supplied)
Audio cable (not supplied)
LANC cable (not supplied)
Notes
• When recording the analog input signals, this VCR can digitally output
the signals from the DV jack for backup. Set DV EE OUT in the menu
to ON (see page 34).
• When you connect output jacks of this VCR to input jacks of the player,
select the input correctly to prevent a humming noise.
• Distorted signals (e.g., when played back at a speed other than normal)
will not be recorded properly.
• The indications displayed on the monitor screen are output only via the
MONITOR connector.
Notes for LANC connection
• With the LANC connection, refer to the instruction for use supplied with
the player VCR.
• The LANC connection transmits signals such as control signals, time
code and time counter data and status data.
• If the other VCR has a LANC
VK-810 Control L connecting cable (not supplied).
• The jacks labeled CONTROL L has the same function as LANC
The jacks labeled REMOTE on other equipment may also have the same.
• This VCR (recorder) receives the time code data from the LANC
only when the other VCR (player) is set to show the time code
indications.
• With the LANC connection, this VCR only works as a slave unit.
Monitor
This VCR
INPUT OUTPUT MONITOR
CONTROL S
S VIDEO
SYNC
INT
VIDEO VIDEO
EXT
CH-1 CH-1/3 CH-1/3
DC IN DC IN
AUDIO AUDIO CH-2 CH-2 CH-2/4 CH-2/4
Foot Switch
(not supplied)
ç: Signal flow
jack of 5-pin DIN type, connect with the
Recorder
REMOTE LANC DV
FOOT
SWITCH
IN/OUT
jacks.
jack