Location And Function Of Parts; Front Panel - Sony DSR-20MD Mode D'emploi

Location and Function of Parts

Location and Function of Parts

Front Panel

1 Cassette compartment
2 1 ON/STANDBY switch
and ON/STANDBY lamp
1 Display section
(see page 7)
3 Remote sensor
4 i PHONES jack
5 2 PHONE LEVEL control knob
6 2 AUDIO INPUT LEVEL control knobs
1 Cassette compartment
Accepts standard-size or mini-size DVCAM digital
videocassettes. When using a mini-size cassette, insert
it into the middle of the compartment.
For details of usable cassettes, see page 4.
2 1 ON/STANDBY switch and ON/STANDBY
lamp
Press this switch to turn on the power, and the ON/
STANDBY lamp lights in green. Press it again to turn
to standby mode, and the lamp goes off.
Note
When the REMOTE/LOCAL switch is set to
REMOTE, you cannot turn the unit to standby mode.
3 Remote sensor
4 i PHONES jack (stereo minijack)
Connect stereo headphones for headphone monitoring
during recording or playback.
The audio signal you want to monitor can be selected
6 GB
Chapter 1 Overview
DUP
COUNTER AUDIO
TIMER
INPUT
SELECT MONITOR
REMOTE
SELECT
TC CH-1/2 REPEAT
MENU
COUNTER MIX OFF
TAPE CH-3/4 REC
REMAIN LOCAL
SET
with the AUDIO MONITOR selector inside of the
door (3).
5 2 PHONE LEVEL control knob
Controls the volume of the headphones connected to
the i PHONES jack.
6 2 AUDIO INPUT LEVEL control knobs
When recording, you can use these knobs to set audio
input levels for CH-1 (channel 1) and CH-2,
respectively.
7 COUNTER RESET button
Press this button to reset the tape counter in the display
window to "0:00:00 (0
work when displaying the time code or the remaining
time.
8 Z EJECT button
Press this button to eject a cassette.
7 COUNTER RESET
button
2 Tape transport
control section
(see page 8)
8 Z EJECT button
3 Inside of the door
(see page 9)
00 00 )." This button does not
H M S