Settings For Recording - Sony DSR-20MD Mode D'emploi

Settings for Recording

Preparation on the recorder (this VCR)
Notes
• Before recording, set the clock on the VCR so that the recording time can
be written into the index signal. You can set the clock by setting the
CLOCK SET menu (see page 34).
• When controlling this unit from an editing controller or a personal
computer connected to the RS-232C
LOCAL switch to REMOTE. When not, set the switch to LOCAL (See
page 9).
• Editing is not possible with a tape that is copyright protected.
1
Power on the video monitor, then set the monitor's input according to
the input signals from this unit.
2
Set up the player to play back a tape.
For details, see "Preparation on the player" on the next page.
3
Power on this unit by pressing the 1 ON/STANDBY switch.
The ON/STANDBY lamp lights in green.
4
Use the COUNTER SELECT selector to select the type of time data to
be used.
Type of time data
Count value of the time counter
Time code
5
Select the video and audio input signals to be recorded.
Press INPUT SELECT to select the desired signal. Each press of this
button cycles through three video signal selection options: video, S-
video, and DV input. Each selection is shown by a lit indicator in the
display window.
Note
Once you have started recording, you cannot change the input signal
selection (except during recording pause mode).
connector, set the REMOTE/
Set the selector to
COUNTER
TC
Chapter 2 Recording and Playback
27 GB