Recording; Connections For Recording - Sony DSR-20MD Mode D'emploi

Recording

Connections for Recording

To digital video equipment with DV jack
This section describes the necessary connections, settings and operations
to perform recording on this unit. The same settings and operations apply
whether you are using the unit as part of an editing system, for dubbing, or
as a stand-alone recorder.
The video and audio signals are sent with hardly any degradation, enabling
high-quality editing. The signal flow is automatically detected so you need
not make separate connections for input and output.
Player
Other VCR
Remote Control Unit
(not supplied)
to the DV to the LANC
jack
jack
Notes
• Audio signals are not output during playing at various speeds.
• With the DV connection, the sound is recorded in the same audio
recording mode as that of the source tape. To record in a different audio
recording mode from the source tape, use the INPUT
instead.
• With the DV connection, tape information (recording date, camcorder
data, etc.) recorded on the source tape is transmitted from the other VCR
(player). As a result, when you play back a recorded tape and press the
DATA CODE button, the same tape information recorded on the source
tape is displayed on the monitor screen. However, contents of the cassette
memory are not transmitted. In addition, the time code is newly recorded
on the tape on this VCR, except when copying a tape in Duplicate mode.
• As for the LANC connection, see "Notes for LANC connection" on the
next page.
Monitor
This VCR
REMOTE
CONTROL S
Foot Switch
(not supplied)
LANC cable (not supplied)
i.LINK cable (DV connecting cable)
(not supplied)
Chapter 2 Recording and Playback
Recorder
FOOT
SWITCH
LANC DV
IN/OUT
ç: Signal flow
connectors
25 GB