Sony DSR-20MD Mode D'emploi page 19

To video equipment without DV jack
Recorder
Other VCR
to the S-video
input jack
to the video input jack
to the audio input jacks
to the LANC jack
S-video cable (not supplied)
Video cable (not supplied)
Audio cable (not supplied)
LANC cable (not supplied)
Notes
• When you connect output jacks of the recorder to input jacks of this
VCR, select the input correctly to prevent a humming noise.
• Distorted signals (e.g., when played back at a speed other than normal)
will not be recorded properly.
• The indications displayed on the monitor screen are output only via the
MONITOR connector.
Notes for LANC connection
• With the LANC connection, refer to the instruction for use supplied with
the recorder VCR.
• The LANC connection transmits signals such as control signals, time
code, time counter data and status data.
• If the other VCR has a LANC
VK-810 Control L connecting cable (not supplied).
• The jacks labeled CONTROL L have the same function as LANC
jacks. The jacks labeled REMOTE on other equipment may also have the
same.
• The other VCR (recorder) receives the time code data from the LANC
jack only when this VCR (player) is set to show the time code
indications.
• With the LANC connection, this VCR only works as a slave unit.
Monitor
INPUT OUTPUT MONITOR
S VIDEO
VIDEO
CH-1 CH-1 CH-1/3
AUDIO AUDIO CH-2 CH-2 CH-2/4 CH-2/4
jack of 5-pin DIN type, connect with the
Chapter 2 Playback and Recording
Player
This VCR
REMOTE LANC DV
FOOT
CONTROL S
SWITCH
IN/OUT
SYNC
INT
EXT
CH-1/3
DC IN
CH-2/4
Ç: Signal flow
15 GB