Sony DSR-20MD Mode D'emploi page 2

Owner's record
The model number is located at the side and front of the unit
and the serial number on the side. Record the model number
and serial number in the space provided below. Refer to
these numbers whenever you call upon your Sony dealer
regarding this product.
Model No. _____________ Serial No. _________________
WARNING
To prevent fire or shock hazard, do not expose the unit to
rain or moisture.
To avoid electrical shock, do not open the cabinet. Refer
servicing to qualified personnel only.
Symbol on the products
This symbol indicates the equipotential
terminal which brings the various parts of a
system to the same potential.
This symbol is intended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
Note:
Model DSR-20MD has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. Model DSR-20MDP has been tested and
found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules and EN60601-1-2,
CISPR 11, Class A. These limits are designed to provide
reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own
expense.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your authority
to operate this equipment.
For the customers in Canada (for
DSR-20MD)
This unit has been certified according to Standard CSA
C22.2 No.601.1.
ii GB
Important safeguards/notices for
use in the medical environments
1. All the equipments connected to this unit shall be certified
according to Standard IEC60601-1, IEC60950, IEC60065
or other IEC/ISO Standards applicable to the equipments.
2. When this unit is used together with other equipment in
the patient area*, the equipment shall be either powered
by an isolation transformer or connected via an additional
protective earth terminal to system ground unless it is
certified according to Standard IEC60601-1.
* Patient Area
3. The leakage current could increase when connected to
other equipment.
4. This equipment generates, uses, and can radiate
frequency energy. If it is not installed and used in
accordance with the instruction manual, it may cause
interference to other equipment. If this unit causes
interference (which can be determined by unplugging the
power cord from the unit), try these measures: Relocate
the unit with respect to the susceptible equipment. Plug
this unit and the susceptible equipment into different
branch circuit. Consult your dealer.
Caution on DC power sources
When you operate the unit using DC power sources, be sure
to establish a ground for this unit using the equipotential
ground terminal .
For an earth cable to be used, consult your Sony dealer.
Disposal
When you dispose the unit or accessories, you must obey the
law in the relative area or country and the regulation in the
relative hospital.
For the customers in the Netherlands
Voor de Klanten in Nederland
Bij dit product zijn batterijen
geleverd. Wanneer deze leeg
zijn, moet u ze niet weggooien
maar inleveren als KCA.