Changing Menu Settings; Changing The Set Up Menu Settings; Menu Contents - Sony DSR-20MD Mode D'emploi

Changing Menu Settings

Changing the SET UP MENU Settings

Menu Contents

Menu options
AUDIO MIX BALANCE
AUDIO MODE
JOG WITH SOUND
This VCR has various functions available, and you can set and check them
on the monitor screen. Before operation, set the clock by setting the
CLOCK SET menu.
You can change the menu settings on the SET UP MENU screen.
If necessary, change the settings manually during editing, etc.
Follow the instructions below to change the settings.
1
Press MENU.
The SET UP MENU appears on the monitor screen.
To cancel the menu settings, press MENU again.
SET UP MENU
AUDIO MIX BALANCE
AUDIO MODE
JOG WITH SOUND
REMOTE CONTROL
RS232C BAUD RATE
DISPLAY POSITION
CAUTION DISPLAY
µ
SELECT µÂ & SET END MENU
2
Press J/j to select the option you want to change, and press SET.
Each menu option appears on the monitor screen (see the table below).
3
Press J/j to change the setting, and press SET.
The menu disappears from the monitor screen.
Initial settings are indicated in bold letters.
Set this option to Description of settings
If you set the AUDIO MONITOR selector to MIX, you can select the
precise balance between channels 1/2 and channels 3/4 by five steps.
Fs48k • To set the audio mode to 2-channel mode (16bit mode). This mode
uses the whole audio area to record one stereo track. You can get
higher sound quality.
Fs32k • To set the audio mode to 4-channel mode (12bit mode). This mode
separates the audio area into two parts. You can record two kinds of
audio, stereo 1 and stereo 2. When recording on this VCR, audio
signals are recorded only in channels 1/2.
ON • To listen to the sound when playing a tape in various speeds.
OFF
• To turn off the sound when playing a tape in various speeds.
33
Chapter 3 Menu Settings
GB