Remote Control Unit - Teac AG-L800 Manuel Du Propriétaire

E

Remote Control Unit

Function buttons
A
Use these buttons to select function modes.
STEREO button (in TUNER page)
B
Use this button to switch an FM broadcast between stereo and
mono modes.
C
Arrowhead buttons (g/t)
Use these buttons to scan through FM/AM freqencies for
receivable broadcasts, automatically or manually, or to select
your preset channels.
D FM/AM button
Use this button to switch between FM and AM bands.
E
TIMER button
Use this button to set a built-in sleep timer.
F
TONE button
Use this button in combination with the VOLUME buttons (+/-)
to adjust the basses and trebles.
G
STEREO button (in AMP ADVANCED page)
Use this button to instantly switch the surround mode to
STEREO.
H
SETUP button
Use this button to set speaker configuration settings.
I
SURROUND button
Use this button to select surround modes.
J
NIGHT MODE button
Use this button to listen to music at low levels but without
loosing clarity.
20
A
B
C
L
M
N
Names of Each Control (2)
D
O
P
Q
R
K INPUT SEL button
This button provides the same function as the DIGITAL INPUT
SELECT button on the AG-L800 itself.
Below the LCD display
L
CH – (H) buttons
On an AMP page this button is used as a stop button (H). On a
TUNER page this button is used to scan for stations on lower
frequencies.
M
PAGE buton
Use this button to switch between two TUNER pages or
between two AMP pages.
N
AMP button
Switch the remote control unit to the AMP mode.
O
VOLUME buttons (+/–)
These buttons provide the same functions as the MASTER
VOLUME knob on the AG-L800 itself.
P
CH + (t) button
On an AMP page this button is used as a play button (t). On a
TUNER page this button is used to scan for stations on higher
frequencies.
Q MUTE button
This button is used to momentarily stop the speaker outputs.
R TUNER button
Switch the remote control unit to the TUNER mode.
ENGLISH
F
I
G
H
J
K