Teac AG-L800 Manuel Du Propriétaire page 48

1
2
3
4
48
Test Tone
Balancing relative volume between speakers
The test tone function is useful to adjust the relative volume
between speakers in DTS, DOLBY DIGITAL or DOLBY PRO
LOGIC II mode.
Once the balance set, you don't have to change the balance as
long as the speakers aren't moved.
< Press the AMP and P buttons on the remote control unit to
display the AMP ADVANCED page.
Note:
< The TEST TONE button does not work in the STEREO mode.
1 Press the TEST TONE button.
The test tone is emitted from each speaker in the following order
at 2-second intervals.
2 Adjust the master volume to the normal listening level.
3 Adjust the volume of center and rear speakers so that the test
tone from each speakers sounds same.
Select a speaker by pressing the SETUP button, and adjust the
level by pressing the arrowhead buttons (g/t). To do this,
you have to first stop the test tone by pressing the TEST TONE
button.
< The level of speakers can be adjusted in 1 dB steps from -10 dB
to +10 dB.
4 When the setting is finished, press the TEST TONE button to
stop the test tone.
Note :
< If certain speakers are not being used, (for example, no center
speaker) the noise sequencer will automatically skip over that
channel.
ENGLISH