Speaker Connections; How To Connect - Teac AG-L800 Manuel Du Propriétaire

Speaker Connections

Caution:
To avoid damaging the speakers by inputting a sudden high-level
signal, be sure to switch the power off before connecting the
speakers.
< Check the impedance of your speakers.
Connect speakers with an impedance of 6 ohms preferably.
< The receiver's red speaker terminals are the + (positive)
terminals and the black terminals are the _ (negative)
terminals.
The + side of the speaker cable is marked to make it
distinguishable from the negative side of the cable. Connect
this marked side to the red + terminal and the unmarked side
to the black terminal.
< Prepare the speaker cords for connection by stripping off
approximately 10 mm or less (no more as this could cause a
short-circuit) of the outer insulation.
Twist the wires tightly together so that they are not straggly.
6
Connection

How to connect

1 Turn the terminal cap counterclockwise to loosen it. The
speaker terminal caps cannot be fully removed from the base.
2 Insert the wire into the terminal fully and turn the terminal cap
clockwise to securely connect it.
3 Make sure it is fastened firm by pulling the cable lightly.
PRE OUT jack
Use this jack to connect additional powered subwoofer or
additional speaker set with power amplifier.
ENGLISH
SPEAKERS,
PRE OUT