Using The Remote Control; Installing Batteries; Battery Replacement - Teac CR-H101 Mode D'emploi

Connecting with banana plugs
You can also make connections using commercially-avail-
able banana plugs. First, connect the banana plugs to the
speaker cables and then connect the plugs to the terminals.
o Keep the caps tightened when in use.
o Carefully read the instructions for the banana plugs that
you are using.
Notice about the European model
In accordance with European safety regulations, con-
necting banana plugs to speaker terminals is not
allowed on European models. The holes into which
banana plugs could be inserted have been covered
with black caps. Connect speakers using bare wires or
spade lugs. If a black cap should become separated
from its terminal, return it to its original position.

Using the remote control

Precautions for use
V Misuse of batteries could cause them to
rupture or leak leading to fire, injury or
the staining of items nearby. Please read
and observe the precautions on page 3
carefully.
o When using the remote control, point it toward the
remote control signal receiver on the main unit from a
distance of 5 m (16 ft) or less. Do not place obstructions
between the main unit and the remote control.
o The remote control might not work if the remote control
signal receiver on the main unit is exposed to sunlight or
bright lights. In this case, try moving the main unit.
o Beware that use of this remote control could cause the
unintentional operation of other devices that can be
controlled by infrared rays.

Installing batteries

Remove the cover on the back of the remote control, and
insert 2 AAA batteries into the case, aligning them with the
¥ and ^ indications. Replace the cover.

Battery Replacement

If the operation range of the remote control decreases, the
batteries have become exhausted. In this case, replace the
batteries with new ones.
Dispose of the used batteries according to the instructions
on them or requirements set by your local municipality.
13