Teac CR-H101 Mode D'emploi page 11

A
FM antenna
When receiving an FM broadcast, extend this antenna
and position it for the best reception.
After moving this unit, readjust the position again.
B
USB port
Use to input digital audio from a computer. Connect
to the USB port of a computer to input digital audio
from it.
Use a commercially-available USB cable.
ATTENTION
Install the dedicated TEAC driver software on the com-
puter before connecting the unit (page 25).
C
Analog audio input connectors (LINE IN)
Use these to input analog audio.
Connect an audio output device such as a cassette deck
or MD player to these jacks using commercially-available
RCA cables.
Use commercially-available cables for connections.
Connect the R connector of this unit to the right (R)
connector of the audio output device and the L con-
nector of this unit to the left (L) connector of the audio
output device.
D
Digital audio input connector (OPTICAL)
Input digital audio. Connect the digital audio output
connector of a digital audio device to it.
Use a commercially-available optical digital (TOS)
cable to make the connection.
o Sampling frequencies up to 192 kHz are supported.
E
SUBWOOFER OUT connector
If you want to use a subwoofer, connect it to this
connector.
o The output level is linked to the VOLUME controls
on the front of the unit and on the remote control.
F
Power inlet (~IN)
Insert the included power cord here.
After all other connections are complete, connect the
power cord's plug to a wall outlet.
V Do not use any power cord other than the
one included with this unit. Use of other
power cords could result in fire or electric
shock. Unplug the cord from the outlet
when not using the unit for a long time.
11