Names And Functions Of Parts (Main Unit) - Teac CR-H101 Mode D'emploi

Names and functions of parts (main unit)

A
F G
A
STANDBY/ON (¤) button
Press this button to turn the unit on and put it in
standby. When the unit is ON, the ring around the
button lights blue.
o When this unit is in standby mode, it consumes
standby power. For this reason, we use the term
"standby" rather than "off".
B
Disc slot
Insert a disc here. After a disc is inserted partway, the
unit will automatically draw it in.
C
Skip (.//) buttons
When the playback source is CD, use to skip to the
previous or next track. During playback, press and hold
to search backward/forward.
D
Play/pause (7/9) button
When paused, press to resume playback.
Press during playback to pause.
Press again to resume playback.
E
Stop/eject (8/-) button
Press during playback to stop playback.
When stopped, press to partially eject the disc. Hold
the disc by its edges and pull it out.
16
B C
H I
F
G
H
I
J
D E
PHONES jack
Connect headphones (3.5mm stereo mini plug) here.
o When headphones are connected to the unit,
audio will not be output from the SPEAKERS termi-
nals on its back.
SOURCE knob
Turn to select the playback source.
Remote control signal receiver
Receives signals from the remote control. When oper-
ating the remote control, point it at this sensor.
Display
This shows a variety of information.
VOLUME knob
Use this knob to adjust the volume. To increase the
volume, turn the knob clockwise. To decrease the vol-
ume, turn the knob counterclockwise.
o When the volume is adjusted with the remote
control, the main unit volume knob will not turn
in response.
J