Mennekes Cable de charge en mode 2 avec IC-CPD pour la charge de vehicules electriques Mode D'emploi page 31

Display on IC-CPD
Relay is All seven LEDs flash quickly
welded. (at 2Hz)
Relay wel-
ding detec-
tion error
Over- Green LEDs
heating flash
green at
0.7Hz
Critical Five LEDs red
overheat
Internal Off Red
fault
* The letters describe the charging status of the electric
vehicle.
Device is
damaged
and must be
repaired by the
manufacturer.
Off No vehicle
connected.
Temperature
above 55 °C.
Green Vehicle
connected
Temperature
above 55 °C.
Vehicle is
charged with
a reduced
current of 6A.
Off Temperature
above 65 °C.
Vehicle is
no longer
charged.
Off Internal fault:
Temperature
sensor,
memory
error, RCD
test negative,
temperature
is less than
-32 °C
Resetting Error Messages
)
Disconnect the charging cable by pulling the plug out of
the mains wall socket.
)
Plug the device back in after
Critical faults that indicate damage to the charging cable
will not be reset.
Such faults include:
- Welded relay (device irrevocably defective)
- Temperature sensor defective
- RCD test negative
ten seconds.
31
DE
EN
NL
FR
IT
ES
CZ