Putting The Machine Into Service; General Remarks; Remarks On The Cooling Unit; Connecting The Gas Cylinder - Fronius TransTig 2200 Instructions De Service

Putting the machine into service

General remarks

This section describes how to put the power source into service
-
-
The standard configuration consists of the following components:
-
-
-
-
-
-
-
The steps set out below will give you an overview of how to put the power source into
service.
For detailed information on each of these steps, please refer to the instruction manuals
for the appliances in question.
Remarks on the We recommend using a cooling unit for the following applications and situations:
-
cooling unit
-
-
-
-
The cooling unit is powered from the power source. The cooling unit is ready for operati-
on when the mains switch of the power source is in the "On" position.
Connecting the
gas cylinder
1.
2.
Warning! An electric shock can be fatal. If the machine is plugged into the
mains electricity supply during installation, there is a high risk of very serious
injury and damage. Only carry out work on the machine when
- the mains switch is in the "OFF" position,
- the machine is unplugged from the mains.
for the principal application (TIG welding)
with reference to a standard configuration for a TIG welding installation.
Power source
Cooling unit
TIG manual welding torch
Pressure regulator
Gas cylinder
Gas cylinder holder
Trolley
JobMaster TIG welding torch
Robot welding
Hosepacks over 5 m long
TIG-AC welding
In general, where welding is performed in higher power ranges
Caution! Risk of injury from gas cylinder toppling over.
- Always use a safety strap
- Fix the safety strap at the same height as the top part of the cylinder
- Never fix the safety strap around the neck of the cylinder
Fix the gas cylinder to the trolley
Connect up the gas cylinder:
- Take the protective cap off the gas cylinder
- Briefly turn the gas cylinder valve anticlockwise to blow off any dust and dirt
- Inspect the seal on the pressure regulator
- Screw the pressure regulator onto the gas cylinder and tighten it
20