General Remarks; Magicwave Control Panel - Fronius TransTig 2200 Instructions De Service

General remarks

In this section, the control panels of the MagicWave and TransTig power sources will be
dealt with separately.
MagicWave
control panel
Fig.3
(1) Mode button ... for selecting the operating mode:
Warning! Operating the equipment incorrectly can cause serious injury and
damage. Do not use the functions described here until you have read and
completely understood all of the following documents:
- these Operating Instructions
- all "Operating Instructions" for the system components, especially the
"Safety rules"
(13) (12) (9)
(7)
MagicWave 5000 control panel
(2) 2-step mode
(3) 4-step mode
(5) Rod electrode (MMA) welding
Important!If you select "Rod electrode (MMA) welding" mode (4), the welding
voltage will only be available after a 3-second time-lag.
(11) (10)
(6) (8)
9
(3) (2) (5) (4)
(14) (1)