Roland XV-5080 Mode D'emploi page 6

Préparatifs
Next, check to make sure the board has been installed properly.
1
Turn on the power, as described in "Turning On the Power"
(p. 12).
2
Appuyez sur le bouton [SYSTEM] button, getting the indicator
to light, et then appuyez sur le bouton [F6 (Info)] button.
The System Information page will appear.
fig.00-007.e_80
* If the indicator is blinking, you are in Utility mode. Appuyez sur le bouton
[SYSTEM/UTILITY] button once again, so the indicator is steadily lit.
3
Verify that the name of the Wave Expansion Board is
displayed next to the slot name.
If no board has been installed, or if the wave expansion board is not being
recognized properly, "----------" appears in the display.
fig.00-008.e
* Should you see the above, it's likely that the Wave Expansion Board is not being
recognized properly. Use the procedure in "Turning Off the Power" (p. 12) to turn
the power off, then reinstall the wave expansion board correctly.
6