Roland XV-5080 Mode D'emploi page 5

5
Slots are provided inside the XV-5080 for SRX Series et SR-
JV80 Series boards. Referring to the diagram below, plug the
wave expansion board's connector into the connector at the
wave expansion board slot, et simultaneously insert the board
holder into the hole in the Wave expansion board.
fig.00-004.e(Install)
SRX Series
6
Use the Installation Tool supplied with the Wave Expansion
Board to turn the holders in the LOCK direction, so the board
will be fastened in place.
fig.00-005.e(lock)
7
Use the screws that you removed in step 2 to fasten the cover
back in place.
This completes the installation of the wave expansion board.
Conecter
Holder
SR-JV80 Series
Verrouillé
(LOCK)
Préparatifs
5