Storage; Receipt, Unpacking, Initial Cleaning - Qualified Operator; Installation And Environmental Conditions - Specialised Technician - Arneg Wels-Wels R290 Manuel D'installation Et D'utilisation

Wels-WelsR290
English
of at least 1,000 kg.
Always place the forks at the indicated points in order to avoid the risk of
overturning, and always completely insert the forks.
No unnecessary personnel should be present in the lifting area.
Balance the weight of the unit so as to ensure that the load remains in
equilibrium (Rif. 3)
DO NOT use transportation devices to lift:
with a capacity of less than 1,000 kg
with inappropriate characteristics or that have been affected by use
with non-standard or worn wires or cables
DO NOT use transportation procedures other than those indicated.

10.Storage

DO NOT store the units in uncovered areas where they are subject to weathering
and direct sunlight. Exposure to ultraviolet rays leads to permanent deformation of
the plastic materials and damages the unit's components.
The units must be stored in closed areas, at a temperature between -25°C and
+55°C and with relative humidity between 30% and 90%.
Before storing, check that the packaging is intact and that it doesn't show any
defects that could compromise the preservation of the units.

11.Receipt, unpacking, initial cleaning - qualified operator -

Before starting any unpacking operations, take all possible precautions to avoid injury
to the operator.
The unit may be provided packaged in one of the following ways:
With a wooden frame fixed to the base and a nylon covering held in place by straps
(standard) (Rif. 5);
With cardboard covering (upon request) (Rif. 6);
With a wooden cage (upon request) (Rif. 7).
Upon acceptance of the cabinet:
Ensure that the packaging is intact and there is no obvious damage;
Unpack, ensuring that the unit is not damaged;
Check that all parts of the unit are intact;
If any damage is found, immediately contact your supplier;
Slowly remove the protective film, taking care to not rip it, in order to avoid leaving
traces of glue. If this occurs anyway, they can be removed using appropriate
solvents.
Clean for the first time using neutral products. Dry with a soft cloth. Do not use any
abrasive substances or metal sponges;
For correct disposal of the packaging, note that it consists of: Wood - Polystyrene -
Polythene - PVC - Cardboard.
DO NOT use alcohol to clean the methacrylate parts (Plexiglas).
During the unpacking operations, do not leave packaging elements such as
nails, wood, staples, nylon, etc. lying around and tools used for the operation
such as pliers, scissors, and pincers should not be left in the work area, as
they could cause injury or wounds.
These items should be removed using appropriate methods and placed in the
relevant waste collection locations.

12.Installation and environmental conditions - specialised technician-

Any change to the installation described here must be authorised by ARNEG
Spa.
To guarantee that the technicians assigned to install the unit work safely, the use of
protective tools and clothing required under the safety regulations or laws in effect in
28 05060074 02 19/08/2014