HP ProLiant Manuel page 12

Loose Cable Detected - Logical Drives May Be Marked FAILED Until
Corrected ........................................................................................................ 117
Mirror Data Miscompare .................................................................................. 118
No Configuration for Array Accelerator Board ................................................. 118
One or More Drives is Unable to Support Redundant Controller
Operation ........................................................................................................ 118
Other Controller Indicates Different Hardware Model ..................................... 118
Other Controller Indicates Different Firmware Version ................................... 118
Other Controller Indicates Different Cache Size ............................................. 118
Processor Reduced Power Mode Enabled in RBSU ...................................... 118
Processor Not Started (Processor Stalled) ..................................................... 119
Processor Not Started (Stepping Does Not Match) ........................................ 119
Processor Not Started (Unsupported Processor Stepping) ............................ 119
Processor Not Supported (Unsupported Core Speed) .................................... 119
RIS Copies Between Drives Do Not Match ..................................................... 119
SCSI Port X Drive ID Y Failed - REPLACE (message de panne) ................... 119
SCSI Port X, Drive ID Y Firmware Needs Upgrading ..................................... 119
SCSI Port X, Drive ID Y Has Exceeded the Following Threshold(s) ............... 120
SCSI Port X, Drive ID Y is not Stamped for Monitoring .................................. 120
SCSI Port X, Drive ID Y May Have a Loose Connection... ............................. 120
SCSI Port X, Drive ID Y RIS Copies Within This Drive Do Not Match ............ 120
SCSI Port X, Drive ID Y...S.M.A.R.T. Predictive Failure Errors Have Been
Detected in the Factory Monitor and Performance Data... .............................. 120
SCSI Port X, Drive ID Y...S.M.A.R.T. Predictive Failure Errors Have Been
Detected in the Power Monitor and Performance Data... ................................ 120
SCSI Port X, Drive ID Y Was Replaced On a Good Volume:
(message de panne) ....................................................................................... 121
Set Configuration Command Issued ............................................................... 121
Soft firmware upgrade required ....................................................................... 121
Storage Enclosure on SCSI Bus X has a Cabling Error (Bus Disabled)... ...... 121
Storage Enclosure on SCSI Bus X Indicated a Door Alert... ........................... 121
Storage Enclosure on SCSI Bus X Indicated a Power Supply Failure... ......... 121
Storage Enclosure on SCSI Bus X Indicated an Overheated Condition... ...... 122
Storage enclosure on SCSI Bus X is unsupported with its current firmware
version... .......................................................................................................... 122
Storage Enclosure on SCSI Bus X Indicated that the Fan Failed... ................ 122
Storage Enclosure on SCSI Bus X Indicated that the Fan is Degraded... ...... 122
Storage Enclosure on SCSI Bus X Indicated that the Fan Module is
Unplugged... .................................................................................................... 122
Storage Enclosure on SCSI Bus X - Wide SCSI Transfer Failed... ................. 122
Swapped cables or configuration error detected. A Configured Array of
Drives... ........................................................................................................... 123
Swapped Cables or Configuration Error Detected. A Drive
Rearrangement... ............................................................................................ 123
xii FRWW