Connecting The Receiver; Replacing The Batteries In The Receiver; Inserting Or Replacing The Batteries In The Remote Control; Operating Instructions - Dru SCENIC Instructions D'installation Et Mode D'emploi

INSTRUCTIONS FOR INSTALLATION

Connecting the Receiver

The remote control system comprises a receiver and a
remote control, packed together in one box.The receiver
must be connected to the appliance fitting the batteries.
This is done as follows:
• Take the receiver out of
the box.
• Slide the brown plug of
the cable onto the
receiver circuit board
(fig. 10).
• Connect the white plug
to the connector on the
gas control valve.The
different sized plugs
correspond with the
connector.
• Open the lid.
• Insert 4 penlight batteries
(type AA). Make sure they are the right way round.
• Replace the lid.
• Connect the thermocouple wiring (fig. 23, arrows B)
• Connect the ignition wiring (fig. 23, arrow C)
• Place the remote control receiver in the tray on the
service flap.
• If you are using an adaptor, connect it to the unit
(fig 23, arrow A) and plug the appliance in.
Warning:
Make sure the aerial is not too close to the ignition wire or the
high-voltage transformer (under the cover).This could damage
the receiver (see fig. 3)
correct position of the aerial
1. ignition wire
2. high-voltage transformer
3. aerial
The ignition wire must not be laid along metal elements as
this will weaken the spark.
Make sure the receiver is covered during any building or
finishing work, so that no dust gets in or on it.
Make sure there can be no short circuit between the battery
unit and any metal components of the appliance.
This could damage the remote control (see fig. 2 in the
troubleshooting table)
I.e. the ignition wire must not:
- lie across the receiver (the black box)
- touch or cross the aerial

Replacing the batteries in the receiver

• Open the door from the service flap.
• Take the receiver and open the lid.The batteries are under
that cover.
A
reset
B
C
fig. 23
1.
3.
2.
fig. 3

OPERATING INSTRUCTIONS

• Remove the old batteries and insert the new ones, making
sure that the + and – signs on the batteries correspond
with those in the holder.
Inserting or replacing the batteries
in the remote control
• Remove the cover on the back of the remote control.
• Connect a square battery (type 6LR61) to the clip.
• Fit the battery in the holder.
• Replace the cover.
• The temperature is shown on the display in Fahrenheit, press
both buttons for a few seconds and it will change to Celsius.
NB: Do not throw old batteries in the dustbin.
They should be treated as Chemical Waste.
For the optimal functioning and longer useful life of its
appliance, Dru advises the use of Duracell batteries.
OPERATING INSTRUCTIONS
A

Remote Control - Igniting

Turn button A anti-clockwise to ON.
At the same time, press and hold buttons
you hear a short signal indicating that the ignition process
has begun; now release the buttons.
Continuous signals indicate that the ignition process is
active. A short sound signal (0.2 sec., 1kHz) indicates that
the ignition process has been completed and that there is
sufficient gas flow. Now the appliance will automatically
switch to full load.
Adjustment - Flame Height
In standby mode: Press
Press to decrease flame height or to set appliance at
pilot flame.
Switching the appliance off
The appliance is switched off using the small 'off' button
on your remote control.
"MAN" Mode - Manual Flame Height Adjustment
1. Press to turn on the main burner.
2. Press to increase the flame height.
3. Press to decrease the flame height or to go to pilot
standby position.
28
B
fig. 24
and until
to increase flame height.