Mantel Iron - Dru SCENIC Instructions D'installation Et Mode D'emploi

INSTRUCTIONS FOR INSTALLATION

Mantel Iron

An iron mantel is available by order from your installer. A
mantel serves to support the brickwork above the
fireplace, enabling the stress-free installation of the
appliance.There are two ways of building the fire into the
chimney breast.
1. Mounting, i.e. the front is placed over the chimney breast.
Shorten the iron mantel to the required length and lay it
on the brickwork.We advise you to use 70 mm thick
bricks.
Position the iron mantel as illustrated in fig. 3A. Allow a
space of 5 mm between the top of the heater and the
bottom of the iron mantel so that the supplied packing
cord seals properly.
Fix the threaded rod provided onto the corner of the
iron mantel with two nuts (1). Fix the tightening screw
(2) with the hook (3) to the eye (4) to the other side. Fix
the eye to the wall with a rawlplug. Level it all using the
tightening screw.
Make sure that the front of the appliance (without the
front in place) and the front of the brickwork are flush.
Once the front is fitted, the chimney breast will no
longer be visible.
Threaded rod with tightening screw
(1)
70
Mantel Iron
Packing
Fig. 3A: Mounting
2. Insert, i.e. the front is placed inside the chimney breast.
(4)
(3)
(2)
Mantel Iron
Grey edging
38c-1077
fig. 3
22
Shorten the iron mantel to the required length and lay it
on the brickwork.We advise you to use 100 mm thick
bricks.
Position the iron mantel as illustrated in fig. 3B. Allow a
space of 20 mm between the top of the heater and the
bottom of the iron mantel so that there will be a gap of
5 mm all round the front.
Fix the threaded rod provided onto the corner of the
iron mantel with two nuts (1). Fix the tightening screw
(2) with the hook (3) to the eye (4) to the other side. Fix
the eye to the wall with a rawlplug. Level it all using the
tightening screw.
Scenic/Scenic SL
The requires the use of a service flap.The service flap is
supplied as a standard accessory.
Threaded rod with tightening screw
(1)
100
Fig. 3B: Insert
(3)
(2)
(4)
5