Wilo CRONOLINE-IL-E Série Notice De Montage Et De Mise En Service page 111

No. Designation
5.3.1.0 In1 (sensor value
range)
5.3.2.0 In1 (value range)
5.4.0.0 In2
5.4.1.0 In2 active/inactive
5.4.2.0 In2 (value range)
5.5.0.0 PID parameters
5.5.1.0 P parameter
5.5.2.0 I parameter
5.5.3.0 D parameter
5.6.0.0 Fault
5.6.1.0 HV/AC
5.6.2.0 Emergency opera-
tion speed
5.6.3.0 Auto reset time
5.7.0.0 Other settings 1
5.7.1.0 Display orientation
5.7.2.0 Pressure value cor-
rection
Installation and operating instructions Wilo-CronoLine-IL-E, CronoTwin-DL-E, CronoBloc-BL-E
Type Symbol Values/explanations
Display of sensor value range 1
±
Setting of the value range
Possible values: 0...10 V/2...10 V/
0...20 mA/4...20 mA
Setting for external setpoint
input 2
±
ON
External setpoint input 2 active
OFF
External setpoint input 2 inac-
tive
±
Setting of the value range
Possible values: 0...10 V/
2...10 V/0...20 mA/4...20 mA
Settings for PID control
±
Setting of the proportional term
of the control
±
Setting of the integral term of
the control
±
Setting of the derivative term of
the control
Settings for behaviour in case of
error
±
HV "heating" mode
AC "cooling/air-conditioning"
mode
Display of emergency operation
speed
±
Time until automatic acknowl-
edgement of an error
±
Display orientation
Display orientation
±
When pressure value correction
is enabled, the differential pres-
sure deviation measured by the
differential pressure sensor that
is factory-fitted on the pump
flange is taken into account and
corrected.
Pressure value correction off
Pressure value correction on
English
Display conditions
Not displayed with PID
control
Not displayed when In2 =
inactive
Only displayed when PID
control is active (incl. all
sub-menus)
Only displayed in p-c mode.
Δ
Is not displayed for all pump
variants.
103