Assembly And Adjustments - DeWalt DC411 Guide D'utilisation

ASSEMBLY AND ADJUSTMENTS

Attaching Side Handle
The side handle (E) can be fitted to either
side of the gear case in the threaded holes.
Before using the tool, check that the handle
is tightened se cure ly.
To improve user comfort, the gear case will
rotate 90˚ for cutting operations.
Rotating the Gear Case
WARNING: To reduce the risk of serious personal injury, turn
tool off and and remove battery pack before making any adjust-
ments or removing/installing attachments or accessories.
1. Remove the four corner screws attaching
the gear case to motor housing.
2. Without separating the gear case from
motor housing, rotate the gear case head
to desired position.
NOTE: If the gear case and motor hous-
ing become separated by more than 1/8"
(3.17 mm), the tool must be serviced and
re-assembled by a D WALT service center.
E
Failure to have the tool serviced may cause
brush, motor and bearing failure.
3. Re-install screws to attach the gear case to the motor housing.
Tighten screws to 20 in.-lbs. torque. Overtightening could cause
screws to strip.
Accessories
It is important to choose the correct guards, backing pads and
flanges to use with grinder accessories. See pages 14 and 15 for
information on choosing the correct accessories.
WARNING: Accessories must be rated for at least the speed
recom mended on the tool warning label. Wheels and other acces-
sories running over their rated accessory speed may fly apart and
cause injury. Threaded accessories must have a 5/8"-11 hub. Every
unthreaded accessory must have a 7/8" (22.2 mm) arbor hole. If it
does not, it may have been designed for a circular saw. Use only the
accessories shown on pages 14 and 15 of this manual. Accessory
ratings must always be above tool speed as shown on tool name-
E
plate.
Mounting Guard
MOUNTING AND REMOVING GUARD
WARNING: To reduce the risk of serious personal injury, turn
tool off and and remove battery pack before making any adjust-
ments or removing/installing attachments or accessories.
CAUTION: Guards must be used with all grinding wheels,
cutting wheels, sanding flap discs, wire brushes, and wire
wheels. The tool may be used without a guard only when sanding
with conventional sanding discs. D
provided with a guard intended for use with depressed center
wheels (Type 27) and hubbed grinding wheels (Type 27). The same
guard is designed for use with sanding flap discs (Type 27 and 29)
and wire cup brushes. Grinding and cutting with wheels other than
Type 27 and 29 require different accessory guards included with tool.
A Type 1 guard is provided for use with
a Type 1 wheel. Mounting instructions for
these accessory guards are included in the
accessory package.
1. Open the guard latch (K), and align
the lugs (L) on the guard with the slots
on the gear case (M). This will align the
lugs on the guard with the slots on the
gear case cover.
13
WALT model DC411 is
E
L
M
K