17_1.General Instructions; 17_2.Cleaning Of External Parts (Daily/Weekly); 17_3.Cleaning Of Internal Parts (Monthly) - Arneg Samara RTB Manuel D'installation Et D'utilisation

17_1.General instructions

The surfaces to be cleaned and the detergents and water used for
cleaning must not exceed a maximum temperature of 30°C.
use only neutral type detergents
DO NOT use acid or alkaline detergents (e.g. bleach) which could corrode the
surface
DO NOT use abrasive products, chemical/organic solvents or sharp
instruments which could damage the surfaces of the units.
DO NOT use detergents with unknown chemical compositions
DO NOT spray water or detergent directly onto the electrical parts of the unit
and avoid wetting fans, light fixtures, electrical cables, and all electrical
equipment in general during cleaning operations.
DO NOT touch the unit with wet or damp hands or feet
DO NOT use alcohol or similar products to clean the methacrylate parts
(plexiglass).
DO NOT aim the jet directly at painted or plastic-coated surfaces
DO NOT apply the products directly onto the surfaces to be cleaned
DO NOT use steam cleaning equipment
DO NOT use excessive force during cleaning operations
avoid contact with or inhaling vapours emitted from acid, alkaline or ammonia
products contained in flooring detergents which may oxidise or corrode
stainless steel.
if internal cleaning is done with water jet cleaners (Rif. 8), use a LOW
PRESSURE system (max 30 bar) with an appropriate capacity to remove any
residue present. Excessive pressure could damage the surfaces.
keep a minimum distance of 30cm from the surfaces being cleaned (Rif. 8).
DO NOT bring the jet too close to the dirt, it can cause injury to the operator
and contaminate parts that have already been cleaned, as well as the
environment (Rif. 9).

17_2.Cleaning of external parts (Daily/Weekly)

On a weekly basis, clean all the external parts of the unit using neutral detergents
for domestic use that are compatible with the surfaces to be cleaned, or using
warm soapy water (max 30°C), and removing all traces of detergent.
Rinse with clean water and dry using a soft cloth.

17_3.Cleaning of internal parts (Monthly)

Cleaning the unit's internal parts is done to destroy pathogenic micro-organisms so as
to ensure the protection of the merchandise.
Before beginning to clean the inside of the unit, it is necessary to:
Turn off the power supply
Completely remove all merchandise inside.
Remove all the removable parts, such as display plates, grills, etc.
Wash with lukewarm water (max 30°C).
Disinfect using a detergent with an antibacterial component.
Carefully clean the tank, drip, and water discharge protection grill, eliminating all
foreign bodies that may have fallen into the suction grill, lifting the fan plate if
necessary.
Carefully dry using a soft cloth.
If any ice has formed, contact a qualified refrigeration technician for assistance.
05060129 00 20/09/2012
Samara RTB
English
27