Electrical Connection (Rif. 20) - Specialised Technician - Arneg Samara RTB Manuel D'installation Et D'utilisation

Samara RTB
English
Evaluate which means to use to mount the unit safely (2-3 persons, fork lift)
Fasten the frame to a wall which is able to support the weight of the unit including
the weight of the merchandise contained in it.
To fasten the frame to the wall use anchors (not supplied) adequate for the
structure, and able to support the weight of the unit complete with the weight of the
merchandise. Minimum capacity anchors P=300 kg each
L
1250 mm
1875 mm
2500 mm
The frame has 8 holes Ø=10mm.
Before fastening the screws use a level (3) to make sure the frame is perfectly
horizontal.
After having attached the frame correctly to the wall, position the unit with the
hooks (2) located on the rear.
Carefully bring the unit close to the frame, make the hooks meet the slots.
Hook the unit
Make sure that the hooks are perfectly in line with the slots (Rif. 20)
Do not position the cabinet:
in environments with the presence of explosive gaseous substances;
outdoors and therefore where there are atmospheric agents;
near heat sources (in direct sunlight, near heating systems, incandescent lights,
etc.)
near air currents (near doors, windows, air-conditioning/heating systems, etc.)
exceeding speeds of 0.2 m/sec.
Before connecting the unit to the electricity, ensure that the plate data corresponds to
the characteristics of the electrical system to which it is to be connected.
For the unit to function properly, the temperature and relative humidity must not exceed
the limits for climate class 3 (+25°C; R.H. 60%) as established in EN-ISO 23953 - 2
regulations, under which the unit was tested

11.Electrical connection (Rif. 20) - specialised technician -

BEFORE STARTING ANY OPERATION, FIRST DISCONNECT THE SYSTEM FROM
THE POWER SUPPLY!
The systems must be completed in accordance with the regulations that
govern construction, installation, use, and maintenance as envisaged under
the norms in effect in the country where the unit is installed.
ARNEG Spa declines any responsibility with regards to the user and third-
parties for damages caused by breakdowns or malfunctioning of the systems
installed upstream to the unit and for damages caused by the same due to
causes directly attributable to malfunctioning of the electrical system.
The unit must be protected upstream by an automatic omnipolar
thermomagnetic switch with appropriate characteristics. This must also act as
a general line disconnection switch.
Establishment of the electrical power supply line to the point of where it connects to the
unit is the responsibility of the Client. The dimensions of the electrical energy power
supply line must be determined in accordance with the electrical power used by the
unit.
Remove any metal objects worn: rings, watches, bracelets, earrings, etc.
Check the electrical diagrams before carrying out the connection
Check that the voltage supply is as specified on the plate data.
Tell the operator where the switch is so that it can be reached quickly in an
EMERGENCY.
24
Weight
(unit+merchandise)
420 kg
620 kg
810 kg
The electrical system must be earthed!
.
05060129 00 20/09/2012