Dräger X-am 5600 Notice D'utilisation page 15

For your safety
 Before using this product, carefully read these Instructions for Use and
those of the associated products.
 Strictly follow the Instructions for Use. The user must fully understand and
strictly observe the instructions. Use the product only for the purposes
specified in the Intended use section of this document.
 Do not dispose of the Instructions for Use. Ensure that they are retained and
appropriately used by the product user.
 Only trained and competent users are permitted to use this product.
 Comply with all local and national rules and regulations associated with this
product.
 Only trained and competent personnel are permitted to inspect, repair and
service the product as detailed in these Instructions for Use (see chapter
"Maintenance" on page 24). Further maintenance work that is not detailed
in these Instructions for Use must only be carried out by Dräger or
personnel qualified by Dräger. Dräger recommend a Dräger service
contract for all maintenance activities.
 Use only genuine Dräger spare parts and accessories, or the proper
functioning of the product may be impaired.
 Do not use a faulty or incomplete product. Do not modify the product.
 Notify Dräger in the event of any component fault or failure.
Safe coupling with electrical devices
Electrical connections to devices which are not listed in these Instructions for
Use should only be made following consultation with the respective
manufacturers or an expert.
Use in areas subject to explosion hazards
Devices or components for use in explosion-hazard areas which have been
tested and approved according to national, European or international Explosion
Protection Regulations may only be used under the conditions specified in the
approval and with consideration of the relevant legal regulations. The devices or
components may not be modified in any manner. The use of faulty or incomplete
parts is forbidden. The appropriate regulations must be observed at all times
when carrying out repairs on these devices or components.
Definitions of alert icons
The following alert icons are used in this document to provide and highlight
areas of the associated text that require a greater awareness by the user. A
definition of the meaning of each icon is as follows:
Indicates a potentially hazardous situation which, if not avoided, could result in
death or serious injury.
Indicates a potentially hazardous situation which, if not avoided, could result in
physical injury or damage to the product.
It may also be used to alert against unsafe practices.
Indicates additional information on how to use the product.
Intended use
Portable gas detection instrument for the continuous monitoring of the
concentration of several gases in the ambient air within the working area and in
explosion-hazard areas.
Independent measurement of up to 6 gases, in accordance with the Dräger
sensors installed.
Tests and approvals
Marking
See "Notes on Approval", "Marking", Page 303.
The BVS 10 ATEX E 080 X technical suitability test is based on the calibration
with the target gas.
Intended operating area and operating conditions
Areas subject to explosion hazards, classified by zones
The instrument is intended for use in Zone 0, Zone 1 or Zone 2 areas where
there is a risk of explosion, or in mines that are at risk due to the presence of
firedamp. It is designed for use within a temperature range of –20 °C to +40 °C
or +50 °C, and for areas in which gases in explosion groups IIA, IIB or IIC and
temperature class T3 or T4 (depending on the batteries and rechargeable
battery) may be present. If used in mines, the instrument is only to be used in
areas known to have a low risk of mechanical impact.
WARNING
CAUTION
NOTICE
15