Cleaning / Maintenance; Emptying The Dust Drawer; Cleaning The Clamping Mechanism; Spare Parts - Renfert Top spin Mode D'emploi

6. Cleaning / Maintenance

Inside the extractor there are small parts which require maintenance.
Opening the device, other than for the processes described below, is not permissible!
Clean the unit using only a damp cloth.
Do not use any scouring cleaning agents or those containing solvents.
6.1

Emptying the Dust Drawer

The drilling dust passes down the sloped sides of the housing into the
EN
Dust Drawer.
To empty the Dust Drawer:
⇒ Lift the work table up as far as it will go
♦ The work table will click into position.
⇒ Brush the dust residues into the Dust Drawer or remove them by
knocking gently (4), and pull the Dust Drawer out by its lower edge.
⇒ Empty the Dust Drawer.
⇒ First insert the upper part of the Dust Drawer into the housing and
then press the lower part in.
♦ The Dust Drawer will click into place.
If the unit is in an angled working position, it must be tipped back-
wards in order to remove the Dust Drawer.
6.2

Cleaning the Clamping Mechanism

Do not use compressed air to clean the area around the clamping mechanism.
Switch the unit off and remove the power supply.
⇒ Lift the work table up as far as it will go.
♦ The work table will click into position.
⇒ Brush the dust residues into the Dust Drawer or remove them by knocking gently (4. Fig. 1), and pull
the Dust Drawer out by its lower edge.
⇒ Pull off the dust protection hood (11, Fig. 1).
⇒ Press the spindle lock (7, Fig.1) and turn the drill jig (22, Fig. 8) until the spindle lock clicks into place.
⇒ Continue to press the spindle lock.
⇒ Loosen the drill jig by hand.
⇒ Remove chuck.
⇒ Clean the drill jig and chuck.
6.3

Spare Parts

You can find components subject to wear and the spare parts on the spare part list in the internet at
www.renfert.com/p918.
The components excluded from the warranty (such as consumables or parts subject to wear and tear)
are marked on the spare part list.
Serial number and date of manufacturing are shown on the type plate of the unit.
- 10 -
4
Fig. 11