Introduction; Symbols; Safety; Proper Use - Renfert Top spin Mode D'emploi

1. Introduction

1.1

Symbols

In the instructions for use and on the unit itself you will find these symbols with the following meanings:
Danger
This indicates a direct risk of injury. Consult accompanying documents!
Electrical current
This indicates a risk of hazard due to an electrical current.
Laser
Do not look into the laser beam.
EN
Attention
Disregarding this warning may result in damage to equipment.
Note
This provides the operator with useful information to improve and ease use.
The device complies with the requirements of the applicable EU directives.
The device is subject to the EU directive 2002/96/EG (WEEE directive).
► List, particular attention should be paid
• List
- List according to importance
⇒ Instructions / appropriate action / input / operational sequence:
You will be asked to carry out the action in a specified order.
♦ Result of an action / reaction of the device / reaction of the program:
The unit or program reacts as a result of your actions or when a specific incident occurs.
Other symbols are explained as they occur.

2. Safety

2.1

Proper Use

This device is a pinhole drilling unit designed to drill holes for the secure fixation of pins from various
different pin systems in dental arches made from plaster or epoxy resin (e.g. on a polyurethane basis).
The device may also be used to drill holes into acrylic base plates. It is exclusively for use in dental
laboratories or dental practices.
2.2

Improper Use

The device must not be used:
• for drilling into metal
• for milling
The product is not designed for use in the domestic environment.
Any application other than those described in these instructions for use is regarded as improper use.
The manufacturer is not liable for damage caused by incorrect or unauthorised use.
Only spare parts supplied by the company Renfert may be used for this device.
- 2 -