Faults - Piron MARCO POLO PF1004 Mode D'emploi

Faults

ERROR CODES
In the event of an error, all of the oven's electrical parts will switch off. A window will open on the screen
with an error code. See POP UP
When an error is present the only operations that can be performed are switching the oven off and turning it
back on again for a new self-diagnosis.
Chamber temperature
Er01
Probe 1 faulty
Chamber temperature
Er02
Probe 2 faulty
Overtemperature near
Er03
the motors.
Overtemperature close
Er04
to the power panel
cooking chamber fans
Er06 have incorrect number
of revs
Er07 Thermal switches open
Er08 Flue motor fault
Er09 RPM sensor
Er13 EEprom in error mode
Overheating of cooking
Er16
chamber. Critical value.
Fault in the BUS
Er99 channel between
electronic peripherals
Motor develops a fault
Motor develops a fault
Motor or rpm sensor develops a
fault
Electronic system's memory
develops a fault
E n g l i s h
Contact Authorised Service Centre
with the error code
Contact Authorised Service Centre
with the error code
Clean the filters at the back of the
oven. Check whether the fan operates
when the oven is not in stand-by.
Clean the filters located on the back of
the oven. Check that the fan works
when the oven is not in stand-by
mode.
Contact Authorised Service Centre
with the error code
Turn the oven off. When the oven has
cooled down, perform a cooking cycle
with the oven empty. If the error
occurs again or you notice that one of
the fans is not turning you must
contact an Authorised Service Centre
with the error code.
Contact Authorised Service Centre
with the error code
Contact Authorised Service Centre
with the error code
Contact Authorised Service Centre
with the error code
Contact Authorised Service Centre
with the error code
Contact Authorised Service Centre
with the error code
| 56