Adjusting The Feet; Electrical Connection; Connecting Or Replacing The Power Cord - Piron MARCO POLO PF1004 Mode D'emploi

ADJUSTING THE FEET

Do not use the oven without the feet.
Failure to use them would prevent air from passing underneath, which is needed to cool the electrical
components and external walls of the oven, causing overheating that could damage the oven's
components.
The equipment must be level for it to operate correctly; this can be achieved by adjusting the feet during
installation and checking it with a spirit level. Screw and/or unscrew the feet to adjust the height.

ELECTRICAL CONNECTION

WARNING: Connection to the electric power supply must be performed by qualified and authorised
technical personnel in accordance with the international, national and local regulations in force in
the country of installation.
Before connecting the oven to the electric power supply, check that the voltage and frequency of
the power supply matches that specified on the tag plate attached to the back of the oven.

CONNECTING OR REPLACING THE POWER CORD

To connect the equipment to the electric power supply, refer to the label attached to the manual or on
the lower part of the back of the oven, close to the tag plate.
WARNING: the yellow/green earth wire in the power cord must be at least 3 cm longer than the
other wires.
To connect the power cord to the terminal block, proceed as follows:
Unscrew the plug on the cable gland and remove the back cover from the equipment.
Pass the new power cord through the cable gland. Connect the power cord wires to the terminal block
in accordance with the wiring diagrams shown on the label attached to the back of the equipment. Only
make the connections illustrated, inserting the copper jumper and power cord under the screw
together. Each wiring diagram label specifies the type of power cord to be used (HO7RN-F) and the
wire sizes in mm .
²
Replace the cover on the lower part of the back of the equipment, fastening it into place with the
screws and block the cord by fastening the plug onto the cable gland.
Incorrect connection may cause the terminal block to overheat to the point of melting with the
consequent risk of electric shocks.
Check that all of the electrical connections are tightly fastened before connecting the oven to the power
supply.
PE = Yellow/Green: "EARTH" safety wire
N = Blue: neutral wire
L1, L2, L3 = Brown, Grey, Black: live wires
The oven must be connected directly to the electric power supply and must be equipped with an easily
accessible switch installed upstream from the equipment and in accordance with the international, national
and local regulations in force in the country of installation. The contacts of said switch must be separated
in all poles to guarantee complete disconnection in accordance with Class III surge protection.
Correct earthing is compulsory and the earth cable must not be interrupted by the safety switch for any
reason.
E n g l i s h | 35