Programming The Transmitter - Becker Centronic VarioControl VC260 Instructions De Montage Et D'utilisation

Programming the transmitter

Putting the radio receiver into programming mode
Press the programming button for 3 seconds.
The programming indicator lamp (green) shows the device is ready for pro-
gramming.
The radio receiver goes into the programming mode for 3 minutes.
Programming the master transmitter
The master transmitter refers to the very first transmitter
programmed in a receiver. In contrast to subsequently pro-
grammed transmitters, the master transmitter enables,
among other things, the setting of limit positions (for drives
with integr. radio receiver) and the programming or deleting
of further transmitters. Any transmitter that has separate
UP, STOP, DOWN buttons and a programming button can be
a master transmitter.
If a master transmitter is already programmed in the re-
ceiver, press the programming button on the transmitter for
10 seconds.
Press the programming button of the transmitter for 3 seconds whilst in pro-
gramming mode.
▻ The shading solution confirms programming with a nodding move-
ment, i.e., the shading solution moves a few centimetres before re-
versing the same distance. This movement will hereafter be re-
ferred to as "shifting".
► The programming process is now complete.
29 - en