Becker Centronic VarioControl VC260 Instructions De Montage Et D'utilisation page 31

Deleting all transmitters (except the master
transmitter)
Press the programming button on the master transmitter for 3 seconds.
▻ The sun protection shifts to confirm.
Re-press the programming button on the master transmitter for 3 seconds.
▻ The sun protection shifts to confirm.
Re-press the programming button on the master transmitter for 10 seconds.
▻ The sun protection shifts to confirm.
► All transmitters (except the master transmitter) have been deleted from
the receiver.
Overwriting the master
Press the programming button on the radio receiver for 3 seconds.
▻ The programming indicator lamp (green) shows the device is ready
for programming.
▻ The radio receiver goes into the programming mode for 3 minutes.
Now press the programming button of the new master transmitter for 10
seconds.
▻ The sun protection shifts to confirm.
► The new master transmitter has now been programmed and the old mas-
ter transmitter overwritten.
31 - en