Wiring - Becker Centronic VarioControl VC260 Instructions De Montage Et D'utilisation

Connect the radio receiver as follows:
Ensure that there is optimal radio reception.
Check the direction of rotation of the tubular drive. Should
the direction of rotation be incorrect, swap connecting wires
3 and 4 on the tubular drive.
Connection and assembly of the battery
Secure the battery in the housing using the adhesive pads provided. The
12 V plug is optionally available.
Ensure that the point of adhesion is dry, clean and free from
grease.
28 - en

Wiring

4
3
2
1
4
3
2
1