Becker Centronic VarioControl VC260 Instructions De Montage Et D'utilisation page 27

Assembly
1. Drill the holes on the front of the front box element according to the de-
sired drilling plan. Should you opt not to use a front box element, we re-
commend using the optionally available fitting panel for solar panels to
mount the solar panel.
2. Now push the connecting cable of the solar panel through the hole with
16 mm diameter and into the front box element. The foam around the
connecting cable serves as edge protection.
3. Now remove the carrier foil from the adhesive strips on the back of the
solar panel.
Ensure that the point of adhesion is dry, clean and free from
grease.
4. Place the solar panel on the front box element, precisely matching it to
the holes for the aluminium rivets.
5. Now carefully rivet the solar panel and the front box element.
27 - en